(Your shopping cart is empty)

Search

  Home > Rubberized Coatings >

  Hyperglex Rubber Pool Primer - Series 309

 
Fix Cracks & Leaks

Because of Hyperflex® Rubber Pool Primer's unique properties it is able to be applied by a contractor or a homeowner to fill small gaps and coat evenly over joints, seams, fixtures, and other weak areas. It can be brushed, rolled, or sprayed on and cures to a hard and durable rubber liner.

MSDS: ENG : ESP


32 Ounces - $14.95
1 Gallon - $59.95
5 Gallons - $275.95
50 Gallon Drums - $2,757.95


Our Price: $59.95


Availability:: Usually Ships in 1 to 2 Days
Product Code: POOL02

quantity and color

color*: 		  

quantity*: 		  

Qty:  
Description
 
Fix Cracks & Leaks

Because of Hyperflex® Rubber Pool Primer's unique properties it is able to be applied by a contractor or a homeowner to fill small gaps and coat evenly over joints, seams, fixtures, and other weak areas. It can be brushed, rolled, or sprayed on and cures to a hard and durable rubber liner.

Better Products That Make a Better World.
Hyperflex is both eco-friendly and energy efficient. Made from over 50% recycled rubber Hyperflex Rubber Pool Primer is not only extremely flexible and durable but is helping divert waste tires from our already full landfills.
Video
SURFACE PREPARATION - Surface must be clean, dry and free of any foreign matter.
New Concrete Let concrete cure for 28 days before coating. Clean bare concrete with a 10% muriatic acid solution to acid etch the surface. Rinse with water. Then use an alkali detergent (baking soda) to neutralize any remaining acid. Rinse thoroughly. Let dry at least 72 hours.
Previously Painted Pool Remove any grease, oil, wax, dust, dirt and all other foreign material from surface. Do not apply over flaking or peeling paint. Scrub the waterline especially as oily material often collects heavily in this area. After thoroughly cleaning with soap & water rinse and let dry for at least 72 hours.
MATERIAL PREPARATION - Thin up to 15% if needed with water.
APPLICATION - HYPERFLEX RUBBER POOL PRIMER MUST BE USED IN CONJUNCTION WITH HYPERGLASS POOL COATING. Hyperflex may be applied with a roller, sprayer, trowel or brush. Use the largest tip compatible with pump when spraying. Mix thoroughly. Allow 4-6 hours drying time before applying Hyperglass Cool Top Coat.
COVERAGE & DRY TIME - Coverage varies depending on surface and porosity. One gallon of paint will cover approximately 100 square feet with 7-8 mils (.007-.008 inches) of coating. Wait 4-6 hours before applying Hyperglass Pool Coating. Cures in approximately 72 hours.
CLEAN-UP - Clean-up equipment, tools and spills promptly with warm, soapy water.
NOTICE! Do not apply if surface or air temperature is below 45 degrees, or if rain is expected before dry time. Damp or humid conditions will slow dry time. KEEP FROM FREEZING.

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Rubberized Coatings
Pool Coatings
Hyperflex® Rubber Pool Primer


Hyperflex Multipurpose Caulk - Series 301 $42.50
Hyperzinc - Series 1000 $169.00
Hyperliner® - Series 308 $79.95
UPS Next Day Air Saver
Hyperflex Rubber Parking Lot & Driveway Coating - Series 305 $34.95